Resin Trap

Resin traps also named as media traps,are designed to install on either existing and new build strainer bodies to capture the media and resins from loss and prevent them from traveling downstream.

Normally,the resin trap screen is closed one side and has a flange on the other for easy installation.It can be made for flow-in-to-out (FITO) or flow-out-to-in (FOTI) filtration.The resin trap screen has continuous slots and smooth surface,the continuous slots can prevent the loss of ion exchange resin,activated carbon media,filter media,green-sand media,sand and other media.Not only is this essential to prevent the loss of expensive material,but it’s also critical to avoid damaging downstream equipment.

The slot sizes are as small to capture very small particle resins

• Material: stainless steel SS304, SS316, SS316L, S32750，S32205，Hastelloy and other metal alloy wires

• Tube diameter: 1inch to 48 inch

• Surface Profile: 0.75mm*1.45mm, 1mm*2mm, 1.5mm*2.5mm  or other size

• Support rods : 2mm*2.3mm, 2mm*3mm, 3mm*5mm, or other size

• Slot size: 20 micron to 3000 micron (Tolerance:+-5 micron),etc.

• Filtering Direction: Outside to inside and inside to outside Filtering Direction

• Connection type: Commonly is flange, some are threads

• End type: Closed plate

• Note: other specifications available as per request

• Prevents expensive ion exchange resin loss

• Protects pumps and crucial downstream equipment

• Precise slot sizes and open area for efficient particle capture, reducing flow restriction

• Can withstand high temperatures, suitable for hot liquids or gases

• Good machinability, easy to install, and integrate into existing systems